GTX3076R is installed in OEM Maniforld

It changed to innternal Valve though it became a waist gate type when usual because a special T3 flange. 

It made to the GT35 actuator housing on the one size and it corresponded because the exhaust flowing quantity became insufficient in case of usual 3076R, and the EX housing. 

Z32 MAF, and there is no change on externals compared with normality. 

Think wanting to make it to the layout of normality though it roughly becomes the pressure method or pushing in case of 100 [sakushon] because I want to measure still accurate flow. 

Do the thing that resolves the air flow and divides into the sensor and the case. 

It is reborn to a convenient thing when a little working hard. 

[Choi] ..vogue.. [ri]. 

R35 MAF flavor. 

Spend time in single system RB with Z32 because it is not possible to use it in case of 35 MAF. 

 The flow map of flow can be used as much as normality if it matches it because it is low though no goodness is heard because the MAF output changes if the Z32 sensor is put in 100Φ. 

The air flow meter in which the stole is not worn by using the watch of TP well is completed. 

The pressure sensor etc. are not needed if it devises it by 100Φ even if there is a blowing return ..not wearing the stole... 

Room of ..normality.. engine almost. 

I personally like it in the atmosphere that doesn't understand in externals. 

Install a carbon parts inductions BOX in cleaner BOX. 

Because the intake is an assembly, it is thought a very good thing by earning capacity. 

Is it good in externals